Redistribute (Ospf) - Planet Networking & Communication WGS3-2820 User Manual

12.7.37 redistribute (OSPF)

This command configures OSPF protocol to allow redistribution of routes from the specified source protocol/routers.
▫
Default metric—unspecified
type—2
tag—0
▫
Format redistribute {rip | bgp | static | connected} [metric <016777214>] [metric-type {1 | 2}] [tag
<0-4294967295>] [subnets]
▫
Mode Router OSPF Config
no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the specified source protocol/routers.
▫
Format no redistribute {rip | bgp | static | connected} [metric] [metric-type] [tag] [subnets]
▫
Mode Router OSPF Config
12.7.38 maximum-paths (OSPF)
This command sets the number of paths that OSPF can report for a given destination where maxpaths is platform dependent.
▫
Default 4
▫
Format maximum-paths <maxpaths>
▫
Mode Router OSPF Config
no maximum-paths
This command resets the number of paths that OSPF can report for a given destination back to its default value.
▫
Format no maximum-paths
▫
Mode Router OSPF Config
12.7.39 timers spf
Use this command to configure the SPF delay time and hold time. The valid range for both parameters is 0-65535 seconds.
▫
Default delay-time—5
hold-time—10
▫
Format timers spf <delay-time> <hold-time>
▫
Mode Router OSPF Config
12.7.40 trapflags (OSPF)
This command enables OSPF traps.
▫
Default enabled
▫
Format trapflags
User's Manual of WGS3-2820/WGS3-5220
465