Ip Dvmrp - Planet Networking & Communication WGS3-2820 User Manual

Table of Contents

Advertisement

13.2 Distance Vector Multicast Routing Protocol (DVMRP) Commands
This section provides a detailed explanation of the DVMRP commands. The commands are divided into the following different
groups:
◆Show commands are used to display device settings, statistics and other information.
◆Configuration commands are used to configure features and options of the switch. For every configuration command there is
a show command that will display the configuration setting.

13.2.1 ip dvmrp

This command sets administrative mode of DVMRP in the router to active. IGMP must be enabled before DVMRP can be
enabled.
Default
disabled
Format
ip dvmrp
Mode
Global Config
no ip dvmrp
This command sets administrative mode of DVMRP in the router to inactive. IGMP must be enabled before DVMRP can be
enabled.
Format
no ip dvmrp
Mode
Global Config
13.2.2 ip dvmrp metric
This command configures the metric for an interface. This value is used in the DVMRP messages as the cost to reach this
network. This field has a range of 1 to 63.
Default
1
Format
ip dvmrp metric <metric>
Mode
Interface Config
no ip dvmrp metric
This command resets the metric for an interface to the default value. This value is used in the DVMRP messages as the cost to
reach this network.
Format
no ip dvmrp metric
Mode
Interface Config
13.2.3 ip dvmrp trapflags
This command enables the DVMRP trap mode.
Default
disabled
User's Manual of WGS3-2820/WGS3-5220
495

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wgs3-5220

Table of Contents