▫
Default
disabled
▫
Format
auto-summary
▫
Mode
Router RIP Config
no auto-summary
This command disables the RIP auto-summarization mode.
▫
Format
no auto-summary
▫
Mode
Router RIP Config
12.8.5 default-information originate (RIP)
This command is used to control the advertisement of default routes.
▫
Format
default-information originate
▫
Mode
Router RIP Config
no default-information originate (RIP)
This command is used to control the advertisement of default routes.
▫
Format
no default-information originate
▫
Mode
Router RIP Config
12.8.6 default-metric (RIP)
This command is used to set a default for the metric of distributed routes.
▫
Format
default-metric <0-15>
▫
Mode
Router RIP Config
no default-metric (RIP)
This command is used to reset the default metric of distributed routes to its default value.
▫
Format
no default-metric
▫
Mode
Router RIP Config
12.8.7 distance rip
This command sets the route preference value of RIP in the router. Lower route preference values are preferred when
determining the best route. A route with a preference of 255 cannot be used to forward traffic.
▫
Default
15
▫
Format
distance rip <1-255>
▫
Mode
Router RIP Config
User's Manual of WGS3-2820/WGS3-5220
481