Planet Networking & Communication WGS3-2820 User Manual page 197

Selection Criteria
Slot/Port - Specifies all CoS configurable interfaces. The option "Global" represents the most recent global
。
configuration settings. These may be overridden on a per-interface basis.
。 Queue ID - Specifies all the available queues per interface(platform based).
Configurable Data
WRR weights / Minimum Bandwidth - Specifies the minimum guaranteed bandwidth allotted to this queue when
。
scheduling is WFQ. Setting this value higher than its corresponding Maximum Bandwidth automatically increases the
maximum to the same value. WRR weights are the corresponding weights when scheduling is WRR Valid Range is
(1 to 15)
Scheduler Type - Specifies the type of scheduling used for this queue. the scheduling on a interface can be one the
。
following
strict
wfq
Default value is weighted.
Queue Management Type - Queue depth management technique used for queues on this interface. This is only
。
used if device supports independent settings per-queue.
Queue Management Type can only be one of the following:
Default value is taildrop.
Command Buttons
Figure 4-5-30 CoS Interface Queue Configuration
wrr
strict + wrr
strict + wfq
taildrop
User's Manual of WGS3-2820/WGS3-5220
197