Planet Networking & Communication WGS3-2820 User Manual page 271

4.7.1.3 Multicast Mroute Summary
This screen displays selected contents of the Mroute Table in tabular form. If there are no routes in the table you will not be
presented with the Selection Criteria.
Selection Criteria
Source IP - Enter the IP address of the multicast packet source to be combined with the Group IP to fully identify a
o
single route whose Mroute table entry you want to display or clear. You may leave this field blank.
Group IP - Enter the destination group IP address whose multicast route(s) you want to display or clear.
o
Non-Configurable Data
Incoming Interface - The incoming interface on which multicast packets for this source/group arrive.
o
Outgoing Interface(s) - The list of outgoing interfaces on which multicast packets for this source/group are
o
forwarded.
Up Time - The time in seconds since the entry was created.
o
Expiry Time - The time in seconds before this entry will age out and be removed from the table.
o
RPF Neighbor - The IP address of the Reverse Path Forwarding neighbor.
o
Protocol - The multicast routing protocol which created this entry. The possibilities are:
o
Flags - The value displayed in this field is valid if the multicast routing protocol running is PIMSM. The possible
o
values are RPT or SPT. For other protocols an "------" is displayed.
Command Buttons
Search - Search the Mroute table for an entry matching the Source IP (if entered) and Group IP address.
o
Clear Route - Remove the data on the screen for the Source IP (if entered) and Group IP address you have
o
specified.
Figure 4-6-51 Multicast Mroute Summary
PIM-DM
PIM-SM
DVMRP
User's Manual of WGS3-2820/WGS3-5220
271