Planet Networking & Communication WGS3-2820 User Manual page 243

Configurable Data
。 Configured Source - This select box is a dynamic selector and would be populated by only those Source Routes
that have already been configured for redistribute by OSPF. However, the topmost option in the select box would be
"Create", and this allows the user to configure another, among the Available Source Routes. The valid values are
'Static', 'Connected', 'RIP' ,'BGP' and 'Create'.
Available Source - This select box is a dynamic selector and would be populated by only those Source Routes that
。
have not previously been configured for redistribution by OSPF. This select box would appear only if the user
selects "Create" option as Configured Source. The valid values are 'Static', 'Connected', 'RIP' and 'BGP'.
。 Metric- Sets the metric value to be used as the metric of redistributed routes. This field displays the metric if the
source was pre-configured and can be modified. The valid values are (0 to 16777215)
。 Metric Type - Sets the OSPF metric type of redistributed routes.
。 Tag - Sets the tag field in routes redistributed. This field displays the tag if the source was pre-configured, otherwise
0 and can be modified. The valid values are (0 to 4294967295)
Subnets - Sets whether the subnetted routes should be redistributed or not.
。
。 Distribute List - Sets the Access List that filters the routes to be redistributed by the destination protocol. Only
permitted routes are redistributed. If this command refers to a non-existent access list, all routes are permitted. The
valid values for Access List IDs are (1 to 199). When used for route filtering, the only fields in an access list that get
used are
All other fields (source and destination port, precedence, tos, etc.) are ignored.
The source IP address is compared to the destination IP address of the route. The source IP netmask in the access
list rule is treated as a wildcard mask, indicating which bits in the source IP address must match the destination
Figure 4-6-29 OSPF Route Redistribution Configuration
Source IP Address and netmask
Destination IP Address and netmask
Action (permit or deny)
User's Manual of WGS3-2820/WGS3-5220
243