Mdebug - Planet Networking & Communication WGS3-2820 User Manual

4.7.4 Mdebug

4.7.4.1 Mrinfo Run
Use this screen to initiate an mrinfo command. You can use the mrinfo command to find out information about neighboring
multicast routers. While you initiate the query using this screen, the results are displayed on the Mrinfo Show screen.
Configurable Data
Router Interface - Enter the IP address of the router interface for which you want to see the neighbor router
o
information. If you do not enter an address the router will query itself.
Command Buttons
Submit - Initiate the mrinfo command on the router. If the mrinfo command completes successfully the browser will
o
display the Mrinfo Show screen. If the mrinfo command fails, you will see the Mrinfo Run screen again.
Figure 4-6-68 Mrinfo Run
292
User's Manual of WGS3-2820/WGS3-5220