Bandwidth Percent; Class; Expedite Kbps - Planet Networking & Communication WGS3-2820 User Manual

▫ Incompatibilities - Expedite (all forms)

9.5.2 bandwidth percent

This command identifies a minimum amount of bandwidth to be reserved for the specified class instance within the named
policy using a relative rate notation. The committed information rate is specified as a percentage of total link capacity and is an
integer from 1 to 100.
Note: The actual bandwidth allocation does not occur until the policy is attached to an interface in a particular direction.
Note The bandwidth kbps and percent commands are alternative ways to specify the same bandwidth policy attribute.
:
▫
Format bandwidth percent <1-100>
▫
Mode Policy-Class-Map Config
▫ Restrictions - The sum of the committed information rate values for all bandwidth and expedite commands defined within
a policy must not exceed the available link bandwidth of the interface to which that policy is assigned. Violation of this
requirement shall prevent successful attachment of a policy to the interface, or shall cause this command to fail if the
policy is already in service on one or more interfaces.
▫ Policy Type - Out
▫ Incompatibilities - Expedite (all forms)

9.5.3 class

This command creates an instance of a class definition within the specified policy for the purpose of defining treatment of the
traffic class through subsequent policy attribute statements. The <classname> is the name of an existing DiffServ class. Note
that this command causes the specified policy to create a reference to the class definition.
Note The CLI mode is changed to Policy-Class-Map Config when this command is successfully executed.
:
▫
Format class <classname>
▫
Mode Policy-Map Config
9.5.3.1 no class
This command deletes the instance of a particular class and its defined treatment from the specified policy. <classname> is the
names of an existing DiffServ class. Note that this command removes the reference to the class definition for the specified
policy.
▫
Format no class <classname>
▫
Mode Policy-Map Config

9.5.4 expedite kbps

This command identifies the maximum guaranteed amount of bandwidth to be reserved for the specified class instance within
the named policy using an absolute rate notation. The committed information rate is specified in kilobits-per-second (Kbps) and
is an integer from 1 to 4294967295. The optional committed burst size is specified in kilobytes (KB) as an integer from 1 to 128,
with a default of 4.
User's Manual of WGS3-2820/WGS3-5220
390