Show Ip Dvmrp - Planet Networking & Communication WGS3-2820 User Manual

▫
Format ip dvmrp trapflags
▫
Mode Global Config
no ip dvmrp trapflags
This command disables the DVMRP trap mode.
▫
Format no ip dvmrp trapflags
▫
Mode Global Config

13.2.4 show ip dvmrp

This command displays the system-wide information for DVMRP.
▫
Format show ip dvmrp
▫
Modes Privileged EXEC User EXEC
Admin Mode
Version String
Number of Routes
Reachable Routes
The following fields are displayed for each interface.
Unit/Slot/Port
Interface Mode
State
13.2.5 show ip dvmrp interface
This command displays the interface information for DVMRP on the specified interface.
▫
Format show ip dvmrp interface <unit/slot/port>
▫
Modes Privileged EXEC User EXEC
Interface Mode
This field indicates whether DVMRP is enabled or disabled. This is a configured value.
This field indicates the version of DVMRP being used.
This field indicates the number of routes in the DVMRP routing table.
This field indicates the number of entries in the routing table with non-infinite metrics.
Valid unit, slot and port number separated by forward slashes.
This field indicates the mode of this interface.
Possible values are Enabled and Disabled.
This field indicates the current state of DVMRP on this interface.
Possible values are Operational or Non-Operational.
This field indicates whether DVMRP is enabled or disabled on the specified interface. This
496
User's Manual of WGS3-2820/WGS3-5220