Show Mtrace - Planet Networking & Communication WGS3-2820 User Manual

with fresh results.
▫
Default none
▫
Format show mstat
▫
Mode Privileged EXEC

13.1.17 show mtrace

This command is used to display results of multicast trace path from the results buffer pool of the router, subsequent to the
execution/completion of a "mtrace <source> [group] [receiver]" command. The results subsequent to the completion of the
"mtrace" will be available in the buffer pool within 2 minutes and thereafter. A subsequent "mtrace" command would overwrite
the results in the buffer pool.
▫
Default noneFormat show mtrace
▫
Modes Privileged EXEC User EXEC
Hops Away From Destination
Intermediate Router Address
Mcast Protocol In Use
TTL Threshold
Time Elapsed Between Hops
(msecs)
The ordering of intermediate routers between the source and the destination
The address of the intermediate router at the specified hop distance
The multicast routing protocol used for the out interface of the specified
intermediate router.
The Time-To-Live threshold of the out interface on the specified intermediate router.
The time between arrival at one intermediate router to the arrival at the next.
494
User's Manual of WGS3-2820/WGS3-5220