Show Ip Ospf - Planet Networking & Communication WGS3-2820 User Manual

▫
Mode Router OSPF Config
no trapflags
This command disables OSPF traps.
▫
Format no trapflags
▫
Mode Router OSPF Config

12.7.41 show ip ospf

This command displays information relevant to the OSPF router.
▫
Format show ip ospf
▫
Mode Privileged EXEC
NOTE: Some of the information below displays only if you enable OSPF and configure certain features.
Router ID
OSPF Admin Mode
ASBR Mode
RFC 1583 Compatibility
ABR Status
Exit Overflow Interval
External LSA Count
External LSA Checksum
New LSAs Originated
LSAs Received
A 32-bit integer in dotted decimal format identifying the router, about which information is
displayed. This is a configured value.
Shows whether the administrative mode of OSPF in the router is enabled or disabled. This
is a configured value.
Reflects whether the ASBR mode is enabled or disabled. Enable implies that the router is
an autonomous system border router. Router automatically becomes an ASBR when it is
configured to redistribute routes learnt from other protocol. The possible values for the
ASBR status is enabled (if the router is configured to re-distribute routes learnt by other
protocols) or disabled (if the router is not configured for the same).
Reflects whether 1583 compatibility is enabled or disabled. This is a configured value.
Shows whether the router is an OSPF Area Border Router.
Shows the number of seconds that, after entering OverflowState, a router will attempt to
leave OverflowState.
Shows the number of external (LS type 5) link-state advertisements in the link-state
database.
Shows the sum of the LS checksums of external link-state advertisements contained in the
link-state database.
Shows the number of new link-state advertisements that have been originated.
Shows the number of link-state advertisements received determined to be new
instantiations.
466
User's Manual of WGS3-2820/WGS3-5220