Planet Networking & Communication WGS3-2820 User Manual page 253

Configurable Data
。 Age Time - Enter the value you want the switch to use for the ARP entry ageout time. You must enter a valid integer,
which represents the number of seconds it will take for an ARP entry to age out. The range for this field is 15 to
21600 seconds. The default value for Age Time is 1200 seconds.
。 Response Time - Enter the value you want the switch to use for the ARP response timeout. You must enter a valid
integer, which represents the number of seconds the switch will wait for a response to an ARP request. The range
for this field is 1 to 10 seconds. The default value for Response Time is 1 second.
。 Retries - Enter an integer which specifies the maximum number of times an ARP request will be retried. The range
for this field is 0 to 10. The default value for Retries is 4.
。 Dynamic Renew - This controls whether the ARP component automatically attempts to renew ARP Entries of type
Dynamic when they age out. The default setting is Enable.
。 Remove from Table - Allows the user to remove certain entries from the ARP Table. The choices listed specify the
type of ARP Entry to be deleted:
Figure 4-6-37 ARP Table Configuation
All Dynamic Entries
All Dynamic and Gateway Entries
Specific Dynamic/Gateway Entry - Selecting this allows the user to specify the required IP
Address
Specific Static Entry - Selecting this allows the user to specify the required IP Address
None - Selected if the user does not want to delete any entry from the ARP Table
User's Manual of WGS3-2820/WGS3-5220
253