Planet Networking & Communication WGS3-2820 User Manual page 304

Configurable Data
PIMSM Admin Mode - Select enable or disable from the pulldown menu to set the administrative status of PIM-SM
o
in the router. You must enable IGMP before enabling PIM-SM. The default is disable.
Join/Prune Interval - Enter the interval between the transmission of PIM-SM Join/Prune messages. The valid
o
values are from (10 to 3600 secs). The default value is 60.
Data Threshold Rate - Enter the minimum source data rate in K bits/second above which the last-hop router will
o
switch to a source-specific shortest path tree. The valid values are from (0 to 2000 K bits/sec) . The default value is
50.
Register Threshold Rate - Enter the minimum source data rate in K bits/second above which the Rendezvous
o
Point router will switch to a source-specific shortest path tree. The valid values are from (0 to 2000 K bits/sec) . The
default value is 50.
Command Buttons
Submit - Send the updated configuration to the router. Configuration changes take effect immediately. These
o
changes will not be retained across a power cycle unless a save is performed.
Only one multicast routing protocol could be enabled at one time. That means, for example, once
Note
:
the PIM-DM admin mode is enabled, the user is not able to enable the DVMRP.
4.7.6.2 PIM-SM Global Parameters
Non-Configurable Data
Figure 4-6-79 PIM-SM Global Parameters
304
User's Manual of WGS3-2820/WGS3-5220