Lacp Commands; Lacp System-Priority - Planet Networking & Communication WSGW-24020 User Manual

Syntax
show arp
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays entries in the ARP table.
Console# show arp
ARP timeout: 60000 Seconds
Interface IP address
------------ ------------------------ ------------------
e1 10.7.1.102
g2 10.7.1.135

5.11 LACP Commands

5.11.1 lacp system-priority

The lacp system-priority global configuration command configures the system priority. To reset to default, use the no form of
this command.
Syntax
lacp system-priority value
no lacp system-priority
value — Value of the priority. (Range: 1 - 65535)
Default Configuration
The default system priority value is 1.
HW address status
--------
00:10:B5:04:DB:4B Dynamic
00:50:22:00:2A:A4 Static
-22
User's Manual of WGSW-24020/WGSW-48040