Clear Radius Statistics; Dot1X Defaultlogin; Dot1X Initialize; Dot1X Login - Planet Networking & Communication WGS3-2820 User Manual

10.1.3 clear radius statistics

This command is used to clear all RADIUS statistics.
▫
Format clear radius statistics
▫
Mode Privileged EXEC

10.1.4 dot1x defaultlogin

This command assigns the authentication login list to use for non-configured users for 802.1x port security. This setting is
over-ridden by the authentication login list assigned to a specific user if the user is configured locally. If this value is not
configured, users will be authenticated using local authentication only.
▫
Format dot1x defaultlogin <listname>
▫
Mode Global Config

10.1.5 dot1x initialize

This command begins the initialization sequence on the specified port. This command is only valid if the control mode for the
specified port is 'auto'. If the control mode is not 'auto' an error will be returned.
▫
Format dot1x initialize <slot/port>
▫
Mode Privileged EXEC

10.1.6 dot1x login

This command assigns the specified authentication login list to the specified user for 802.1x port security. The <user>
parameter must be a configured user and the <listname> parameter must be a configured authentication login list.
▫
Format dot1x login <user> <listname>
▫
Mode Global Config

10.1.7 dot1x max-req

This command sets the maximum number of times the authenticator state machine on this port will transmit an EAPOL EAP
Request/Identity frame before timing out the supplicant. The <count> value must be in the range 1 - 10.
▫
Default 2
▫
Format dot1x max-req <count>
▫
Mode Interface Config
10.1.7.1 no dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will transmit an EAPOL EAP
Request/Identity frame before timing out the supplicant to the default value, i.e. 2.
▫
Format no dot1x max-req
▫
Mode Interface Config
User's Manual of WGS3-2820/WGS3-5220
405