Ipv6 Neighbor Discovery Commands - D-Link DAS-3636 Cli Reference Manual

The following commands are used to detect IPv6 neighbors on the switch and to keep a running database about these neighbor
devices. The IPv6 Neighbor Detection commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create ipv6 neighbor_cache ipif
delete ipv6 neighbor_cache ipif
show ipv6 neighbor_cache ipif
config ipv6 nd ns ipif
show ipv6 nd
Each command is listed, in detail, in the following sections.
create ipv6 neighbor_cache ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static IPv6 neighbor:
DAS-3626:admin#create ipv6 neighbor_cache ipif System 3FFC::1 00:01:02:03:04:05
Command: create ipv6 neighbor_cache ipif System 3FFC::1 00-01-02-03-04-05
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Parameters
<ipif_name 12> <ipv6addr> <macaddr>
[<ipif_name 12> | all][<ipv6addr> |static |dynamic | all]
[<ipif_name 12> | all ] [ipv6address <ipv6addr> | static | dynamic |all]
<ipif_name 12> retrans_time <uint 0-4294967295>
{ipif <ipif_name 12>}
This command is used to add a static IPv6 neighbor.
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
This command is used to add a static IPv6 neighbor to an existing IPv6
interface previously created on the switch.
<ipif_name 12> – Enter the IPv6 interface name previously created using the create ipif
command.
<ipv6addr> – Enter the IPv6 address of the neighbor device to be added as an IPv6 neighbor
of the IP interface previously entered in this command.
<macaddr> – Enter the MAC address of the neighbor device to be added as an IPv6
neighbor of the IP interface previously entered in this command.
Only Administrator-level users can issue this command.
IP 6 N
V EIGHBOR
50
D C
ISCOVERY OMMANDS
9