Stp Pathcost-Standard - 3Com S7906E Command Reference Manual

The No Agreement Check feature can take effect only on the root port.
Examples
# Enable No Agreement Check on GigabitEthernet 2/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/0/1
[Sysname-GigabitEthernet2/0/1] stp no-agreement-check

stp pathcost-standard

Syntax
stp pathcost-standard { dot1d-1998 | dot1t | legacy }
undo stp pathcost-standard
View
System view
Default Level
2: System level
Parameters
dot1d-1998: The device calculates the default path cost for ports based on IEEE 802.1D-1998.
dot1t: The device calculates the default path cost for ports based on IEEE 802.1t.
legacy: The device calculates the default path cost for ports based on a proprietary standard.
Description
Use the stp pathcost-standard command to specify a standard for the device to use when calculating
the default path costs for ports of the device.
Use the undo stp pathcost-standard command to restore the system default.
By default, the legacy standard is used for calculating the default path cost for ports.
Note that if you change the standard that the device uses in calculating the default path cost, the port
path cost value set through the stp cost command will be invalid.
1-24