Creating A Link Aggregation Group - 3Com Baseline 2928 PWR Plus User Manual

Table 1-2 Static aggregation group configuration task list

Creating a Link Aggregation Group

Displaying Information of an Aggregate Interface
Configuring a dynamic aggregation group
Perform the tasks in
Table 1-3 Dynamic aggregation group configuration task list
Creating a Link Aggregation Group
Displaying Information of an Aggregate Interface
Setting LACP Priority
Displaying Information of LACP-Enabled Ports
Creating a Link Aggregation Group
Select Network > Link Aggregation from the navigation tree, and then click Create to enter the page
as shown in Figure
Task
Table 1-3 to configure a dynamic aggregation group.
Task
1-1.
Required
Create a static aggregate interface and configure
member ports for the static aggregation group
automatically created by the system when you
create the aggregate interface.
By default, no link aggregation group exists.
Optional
Perform this task to view detailed information of
an existing aggregation group.
Required
Create a dynamic aggregate interface and
configure member ports for the dynamic
aggregation group automatically created by the
system when you create the aggregate interface.
LACP is enabled automatically on all the
member ports.
By default, no link aggregation group exists.
Optional
Perform this task to view detailed information of
an existing aggregation group.
Optional
Perform the task to set LACP priority for the local
system and link aggregation member ports.
Changes of LACP priorities affect the
selected/unselected state of link aggregation
member ports.
The default port LACP priority and system LACP
priority are both 32768.
Optional
Perform the task to view detailed information of
LACP-enabled ports and the corresponding
remote (partner) ports.
1-5
Remarks
Remarks