Page 130 of 600
553-3001-368
Standard 20.00
Nortel IP Phone 2004
Procedure 18
Installing the IP Phone 2004 for the
first time using manual configuration
Timing information
There are only 4 s between plugging in the IP Phone 2004 power
transformer and the appearance of the Nortel logo in the middle of the
display. When you see the logo, you have 1s to respond by pressing the
four soft keys at the bottom of the display in sequence from left to right,
one at a time. If you miss the 1-s response time, the IP Phone 2004
attempts to locate the connect server. You can begin the power-up
sequence again, or you can double-press the Services key to open the
network diagnostic utilities to access the IP Phone settings. See
Appendix E "IP Phone diagnostic utilities" on
To edit network configuration the following soft keys are available:
•
OK—accept current settings and proceed to the next configuration
option. If all configuration options are presented, the configuration is
saved and the IP Phone reboots with the saved changes.
•
BkSpace—backspace a configuration entry to change it
•
Clear—clear an entire configuration entry
•
Cancel—cancels out of network configuration. The IP Phone reboots
without saving changes.
1
At the prompt EAP Enable?, enter 1-Yes (1 for Yes) if the network
infrastructure supports 802.1x port-based network access control. Enter
DeviceID and Password.
If you select No, you will not be prompted to enter Device ID and
Password.
For more information on EAP, refer to Appendix C "802.1x Port-based
network access control" on
2
At the prompt, LLDP Enable?, enter 1-Y (1 for Yes, default), or 0-N (0 for
No).
For more information about LLDP, refer to Appendix D "802.1ab Link
Layer Discovery Protocol" on
December 2006
IMPORTANT!
page
page
493.
page
495.
497.