Replacing An Ip Phone 1120E - Nortel 1110 Fundamentals

3
4
5
6

Replacing an IP Phone 1120E

Two IP Phones cannot share the same TN. You must remove the IP Phone 1120E
that currently uses the TN.
Procedure 71
Replacing an IP Phone 1120E
Step
1
2
3
4
Copyright © 2003–2007, Nortel Networks
.
Press OK when the node number displays.
If
the node password is enabled and
is not NULL
the node password is disabled
Enter the password at the password screen and press OK.
A TN screen displays.
To obtain the password, enter the nodePwdShow command in
Element Manager. For further information, see Element Manager
System Reference—Administration (NN43001-632).
Select the Clear soft key to clear the existing TN.
Enter the new TN.
Action
Obtain the node and TN information of the phone you want to
replace.
Disconnect the IP Phone 1120E that you want to replace.
Follow Procedure 65 "Configuring the IP Phone 1120E" (page
332) to install and configure the IP Phone 1120E.
Enter the same TN and Node Number as the IP Phone 1120E you
replaced. The Call Server associates the new IP Phone 1120E with
the existing TN.
Nortel Communication Server 1000
IP Phones Fundamentals
NN43001-368 02.01 Standard
Release 5.0 7 December 2007
Replacing an IP Phone 1120E 351
Then
a password screen displays. Go to
Step 4.
a TN screen displays. Go to
—End—
ATTENTION
—End—
Step 5.