Avaya S8100 Series Manual page 111

!
CAUTION:
DO NOT CLICK CANCEL past this point. Be patient. If the installation fails, a
CAUTION:
message appears on the Reboot in Progress screen.
4. When the reboot is complete, click Continue to display the Update Tripwire Database
screen. If you selected the install license files option earlier in the process, you are
prompted to install the updated license and Avaya authentication files.
Click Continue to install the license and Avaya authentication files.
5. Clicking Continue again displays the Update Tripwire Database screen.
6. Unless instructed in your planning documents to update the tripwire database, select Do
not update the tripwire data base now and click Continue.
The system displays the Installation Complete screen.
7. Click Close.
You are returned to the main menu.
8. Go to Verifying software operation
Verifying reboot progress
To check the reboot process.
1. Click Start > Run to open the Run dialog box.
2. Type command and press Enter to open an MS-DOS window.
3. Type arp -d 192.11.13.6 and press Enter to clear the ARP cache in the laptop. This
command responds with one of the following responses:
The command line prompt when the cache is cleared.
●
The following message is when the specified IP address does not currently contain an
●
entry in the ARP cache:
The specified entry was not found.
4. Type ping -t 192.11.13.6 to access the media server. The -t causes the ping to
repeat until you get a response. When you get a response, in about 3 minutes, wait an
additional 30 seconds before you go back to the Web interface.
5. Type ctrl c to stop the ping.
6. Close the MS-DOS window.
on page 112
Upgrade tasks
Issue 2.1 June 2006 111