r50813[0...4]
P2P IF transmit data display / P2P tr data disp
DC_CTRL
Can be changed: -
Data type: Unsigned16
P-Group: -
Not for motor type: -
Min
-
Description:
Displays the transmit data for the peer-to-peer interface (P2P IF).
The signal source for the data to be transmitted is set via connector input p50794[0 to 4].
Index:
[0] = Word 1
[1] = Word 2
[2] = Word 3
[3] = Word 4
[4] = Word 5
Dependency:
Refer to: p50794
p50816
BI: P2P IF receive enable signal source / P2P recv ena sig s
DC_CTRL
Can be changed: T
Data type: Unsigned32 / Binary
P-Group: -
Not for motor type: -
Min
-
Description:
Sets the signal source to enable data to be received on the peer-to-peer interface (P2P IF).
1 signal: Data receive enabled
0 signal: Data receive not enabled
p50817
BI: P2P IF transmit enable signal source / P2P tr ena sig s
DC_CTRL
Can be changed: T
Data type: Unsigned32 / Binary
P-Group: -
Not for motor type: -
Min
-
Description:
Sets the signal source to enable data to be transmitted on the peer-to-peer interface (P2P IF).
1 signal: Data transmission enabled
0 signal: Data transmission not enabled
p50820
PPI/USS bus terminator / PPI/USS bus term
DC_CTRL
Can be changed: U, T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description:
Sets the bus terminator for the RS485 interface (PPI/USS, X178).
Value:
0:
1:
SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
OFF
ON
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
1
2 Parameters
2.2 List of parameters
Access level: 1
Func. diagram: 9300
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 2
Func. diagram: 9300
Unit selection: -
Expert list: 1
Factory setting
1
Access level: 2
Func. diagram: 9300
Unit selection: -
Expert list: 1
Factory setting
1
Access level: 1
Func. diagram: 2410
Unit selection: -
Expert list: 1
Factory setting
1
521