Telegram Diagnostics Selection / Telegr Diag Sel; Telegram Diagnostics Signals / Telegr Diag Sig - Siemens SINAMICS DCM List Manual

2 Parameters
2.2 List of parameters
1: Activate download.
-1: activate the download and carry out a reset.
0: Download successfully completed.
> 1: Fault code
011: DRIVE-CLiQ component has detected a checksum error.
015: The selected DRIVE-CLiQ components did not accept the contents of the firmware file.
018: Firmware version is too old and is not accepted by the component.
019: Firmware version is not suitable for the hardware release of the component.
101: After several communication attempts, no response from the DRIVE-CLiQ component.
140: Firmware file for the DRIVE-CLiQ component not available on the memory card/device memory.
143: Component has not changed to the mode for firmware download. It was not possible to delete the existing
firmware.
144: When checking the firmware that was downloaded (checksum), the component detected a fault. It is possible
that the file on the memory card/device memory is defective.
145: Checking the loaded firmware (checksum) was not completed by the component in the appropriate time.
156: Component with the specified component number is not available.
Additional values:
Only for internal Siemens troubleshooting.
Dependency: Refer to: p7828
Note: p7829 is automatically set to 0 after the firmware has been successfully downloaded.
The new firmware only becomes active at the next system run-up.
p7830

Telegram diagnostics selection / Telegr diag sel

DC_CTRL, Can be changed: T
DC_CTRL_R,
Data type: Integer16
DC_CTRL_R_S,
P-Group: -
DC_CTRL_S
Not for motor type: -
Min
0
Description: Selects a telegram whose contents should be shown in r7831 ... r7836.
Value: 0:
1:
2:
3:
Dependency: Refer to: r7831, r7832, r7833, r7834, r7835, r7836
r7831[0...23]

Telegram diagnostics signals / Telegr diag sig

DC_CTRL, Can be changed: -
DC_CTRL_R,
Data type: Integer16
DC_CTRL_R_S,
P-Group: -
DC_CTRL_S
Not for motor type: -
Min
0
Description: Displays the signals contained in the selected telegram (p7830).
Value: 0:
1:
102:
110:
111:
112:
113:
114:
115:
10500: ENC_ID_TIME_PRETRIGGER
10501: ENC_ID_TIME_SEND_TELEG_1
10502: ENC_ID_TIME_CYCLE_FINISHED
10503: ENC_ID_TIME_DELTA_FUNMAN
298
Reserved
First cyclic receive telegram sensor 1
First cyclic receive telegram sensor 2
First cyclic receive telegram sensor 3
UNUSED
UNKNOWN
SAPAR_ID_DSA_ALARM
SAPAR_ALARMBITS_FLOAT_0
SAPAR_ALARMBITS_FLOAT_1
SAPAR_ALARMBITS_FLOAT_2
SAPAR_ALARMBITS_FLOAT_3
SAPAR_ALARMBITS_FLOAT_4
SAPAR_ALARMBITS_FLOAT_5
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
3
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
15157
List Manual (LH8), 02/2015, 6RX1800-0ED76
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 4
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
SINAMICS DCM