Recorder Function Save Interval / Rec Fct T_Save; Start/Stop Recorder Function / Rec Fct Startstop; Recorder Function Number Of Entries / Rec Fct Num Ent; Fault Message Response Delay Time / F Delay_Time - Siemens SINAMICS DCM List Manual

p51704

Recorder function save interval / Rec fct t_save

DC_CTRL Can be changed: U, T
Data type: Unsigned32
P-Group: -
Not for motor type: -
Min
1
Description: Sets the save interval,
during which the signals recorded internally are saved to the following recording file:
\USER\SINAMICS\DATA\LOG\Track.csv
Dependency: Refer to: p51700, p51701, p51702, p51703, p51705, p51706
Notice: The value is set in minutes.
p51705

Start/stop recorder function / Rec fct StartStop

DC_CTRL Can be changed: U, T
Data type: Integer16
P-Group: -
Not for motor type: -
Min
0
Description: Setting to start and stop the recorder function.
Value = 1:
Recording is started and stopped after reaching of the number of entries set in p51706. p51705 is set to 0.
Value = 2:
Recording is started: After reaching of the number of entries set in p51706, the file is overwritten from the beginning.
Recording runs until it is stopped by setting of p51705 = 0.
Value: 0:
1:
2:
Dependency: Refer to: p51700, p51701, p51702, p51703, p51704, p51706
Notice: Starting the recorder function overwrites any existing recording file.
p51706

Recorder function number of entries / Rec fct num ent

DC_CTRL Can be changed: U, T
Data type: Unsigned32
P-Group: -
Not for motor type: -
Min
10
Description: Sets the number of entries in the recorder function's recording file.
Dependent upon the start command (p51705 = 1 or 2), recording is stopped after this number of entries has been
reached or the recording file is overwritten from the beginning.
Dependency: Refer to: p51700, p51701, p51702, p51703, p51704, p51705
p51780

Fault message response delay time / F delay_time

DC_CTRL Can be changed: U, T
Data type: FloatingPoint32
P-Group: -
Not for motor type: -
Min
0.000 [s]
Description: All fault message responses are not immediately initiated, but only after a parameterizable delay time.
SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
Stop
Start
Start with overwrite
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
60
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
2
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
100000
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
60.000 [s]
2 Parameters
2.2 List of parameters
Access level: 2
Func. diagram: 8050
Unit selection: -
Expert list: 1
Factory setting
1
Access level: 2
Func. diagram: 8050
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 2
Func. diagram: 8050
Unit selection: -
Expert list: 1
Factory setting
3600
Access level: 2
Func. diagram: 2651
Unit selection: -
Expert list: 1
Factory setting
0.000 [s]
541