Change Message Type Type / Change Type Type - Siemens SINAMICS DCM List Manual

Dependency: Selects the fault or alarm selection and sets the required type of message realized under the same index.
Refer to: p2119
Note: Re-parameterization is also possible if a message is present. The change only becomes effective after the message
has gone.
p2119[0...19]

Change message type type / Change type type

CU_DC, CU_DC_R, Can be changed: U, T
CU_DC_R_S,
Data type: Integer16
CU_DC_S, DC_CTRL,
P-Group: Messages
DC_CTRL_R,
Not for motor type: -
DC_CTRL_R_S,
DC_CTRL_S
Min
1
Description: Sets the message type for the selected fault or alarm.
Value: 1:
2:
3:
Dependency: Selects the fault or alarm selection and sets the required type of message realized under the same index.
Refer to: p2118
Note: Re-parameterization is also possible if a message is present. The change only becomes effective after the message
has gone.
The message type can only be changed for messages with the appropriate identification (exception, value = 0).
Example:
F12345(A) --> Fault F12345 can be changed to alarm A12345.
In this case, the message number that may be possibly entered in p2100[0...19] and p2126[0...19] is automatically
removed.
p2119[0...19] Change message type type / Change type type
TM150, TM15DI_DO, Can be changed: U, T
TM31
Data type: Integer16
P-Group: Messages
Not for motor type: -
Min
1
Description: Sets the message type for the selected fault or alarm.
Value: 1:
2:
3:
Dependency: Selects the fault or alarm selection and sets the required type of message realized under the same index.
Refer to: p2118
Note: Re-parameterization is also possible if a message is present. The change only becomes effective after the message
has gone.
The message type can only be changed for messages with the appropriate identification (exception, value = 0).
Example:
F12345(A) --> Fault F12345 can be changed to alarm A12345.
In this case, the message number that may be possibly entered in p2100[0...19] and p2126[0...19] is automatically
removed.
r2120 CO: Sum of fault and alarm buffer changes / Sum buffer changed
All objects Can be changed: -
Data type: Unsigned16
P-Group: Messages
Not for motor type: -
Min
-
Description: Displays the sum of all of the fault and alarm buffer changes in the drive unit.
SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
Fault (F)
Alarm (A)
No message (N)
Fault (F)
Alarm (A)
No message (N)
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
3
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
3
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
2 Parameters
2.2 List of parameters
Access level: 3
Func. diagram: 8075
Unit selection: -
Expert list: 1
Factory setting
1
Access level: 3
Func. diagram: 8050, 8075
Unit selection: -
Expert list: 1
Factory setting
1
Access level: 4
Func. diagram: 8065
Unit selection: -
Expert list: 1
Factory setting
-
171