9 Original Equipment Manufacturer's (OEM) Cycles
9.1 HEIDENHAIN Standard Cycles
December 2001
Many common machining tasks requiring several routine steps are stored
ready-programmed in the TNC as standard cycles. Coordinate transformations
and several special functions are also available as cycles. The cycles are
divided in groups and are called by soft key.
The TNC graphically illustrates the type of information required in the input
parameters.
There are:
n
cycles that go into effect immediately upon definition, and
n
cycles that must be called with CYCL CALL after they have been defined.
The User's Manual for the TNC provides a comprehensive description of the
HEIDENHAIN standard cycles.
HEIDENHAIN Standard Cycles
9 – 3