Ricoh V-C3 D081 Field Service Manual page 357

[A] Filter frame
[B] Filter
• This filter must be replaced every time the developer is replaced.
2. Insert the plug [A] into the toner port.
3. Remove the plastic cover [B] ( x2). Use the tip of a small screwdriver to dislodge the cover.
4. Attach the metal jig [A] to the end of the development roller. The jig must be set as shown.
• The D-shaped hole of the metal jig must fit over the D-shaped shaft tip. If the hole of the metal
jig is not aligned with the shaft, rotate the D-shaped shaft tip to position the shaft so the metal jig
can be attached.
5. Attach the brown coupling [B] (removed from the PCU stand) to the other end of the development
roller.
PCU
4
355