Ricoh V-C3 D081 Field Service Manual page 346

4. Replacement and Adjustments
Re-installation of the Drum
This procedure is the same for the YMC PCUs and the K PCU.
• Always dust the surface of a new drum before you install it.
• If you have removed the drum and intend to re-install the same drum, the surface of this drum should
be dusted as well.
Before you begin...
• Make sure that you have the correct type of dusting powder for the drum. Use only Lubricant Powder
B1329700 (specially designed for this machine).
• Never use Setting Powder 54429101 because it could damage the drum and charge roller.
4
• Never use the yellow toner of the D081/D082 or D014/D015 copiers because it contains
developer that could damage the drum and ITB.
To dust the drum:
1. Spread a small amount of lubricant powder on a clean sheet of paper.
2. Dip a clean, dry cloth into the lubricant powder.
3. Dust the surface of the drum with the cloth until the entire surface is covered.
4. When you reinstall the drum:
• Reinstall the front end of the drum first.
• Never rotate the drum manually after reinstalling it.
Reinstallation: Drum
1. After re-installation, turn the machine on and do the appropriate SP settings, based on what was
replaced.
344