Ricoh V-C3 D081 Field Service Manual page 70

2. Installation
Reattach the Faceplate
2
1. Attach the faceplate [A] with the screws in the sequence shown by the numbers above ( x 5).
• Do not tighten these screws too much.
2. Reattach the fan connector [B].
• Make sure the fan connector is not pinched behind the faceplate.
Filling the PCU Units with Developer
Before You Begin...
• Follow this procedure in the order described below.
• Do not turn the machine on or off or open the front door until you are instructed to do so.
• The toner hopper unit must be off the machine (removal described above).
Setting the Developer Bottles
68