Ricoh V-C3 D081 Field Service Manual page 247

No. Name
Slot C
Upper Slot
Lower Slot
USB 2.0
100BaseT LAN
USB Ch1
USB Ch2
TEL
Line 1
ISDN
Line 2
Line 3
Important Notes
• Only two SD Card slots are available for applications.
• The VM card is already inserted in the lower slot when the machine leaves the factory.
• Other applications must be inserted in the upper slot.
• If more than one application is required in the upper slot, the applications must be moved to the same
SD card with SP5873-1.
Gigabit Ethernet (D377-21). The EFI (Fiery) controller is connected
through Gigabit Ethernet.
• Data Overwrite Security (D497)
• PostScript3 (D497)
• Browser Unit (D497)
• HDD Encryption Unit (D377-16)
Contains the VM card when the machine leaves the factory. When used
for firmware updates, and moving applications to another SD card with
SP5873 (Apli Move), the VM card must be removed and then re-
installed after the update procedure is completed.
Built-in for connection of USB devices.
Standard LAN connection point.
For future use (PictaBridge, other application devices).
Note: These connection points are covered with a plate. Remove the
screw, rotate the plate and reattach it with the screw so that the slots
are exposed, then attach the connector.
Jack for telephone connection
Jack for main telephone line from the outside for connection to Fax
Option (D356).
Jack for ISDN connection Japan Only
Jack for a 2nd line connection to G3 Interface Unit Type C7500 (D357)
when this option is installed.
Jack for a 3rd line connection to G3 Interface Unit Type C7500 (D357)
when this option is installed.
MFP Controller Options
Description
2
245