Ricoh V-C3 D081 Field Service Manual page 198

2. Installation
1. The first step depends on whether you will install the Cover Interposer B704.
If you will not install the Cover Interposer B704:
• Remove the strip from the sponge cushion [A] and attach it to the finisher, then go to Step 2.
2
• Do not put the sponge in a position that will prevent air flow through the air duct [B] on the copier
shown above after the finisher is connected to the copier.
• Use a short screwdriver to attach the grounding plate [C] ( x 2, M3 x 6).
If you will install the Cover Interposer B704:
• Do not attach the sponge cushion to the finisher. It must be attached to the cover interposer.
• Do not attach the grounding plate [C] to the finisher. It must be attached to the cover interposer.
• Install the interposer on the finisher before you dock the finisher to the copier. (
• After installing the interposer, continue from 'Attaching the Trays' below.
196
p.183).