Ricoh V-C3 D081 Field Service Manual page 239

The illustration above shows the actual scale on the left side of the unit Multi Folding Unit (D454). In the
illustration below, the red lines indicate the joint bracket where adjustments are done to eliminate skew
and to correct side-to-side registration (this illustration shows the machine and peripherals as viewed from
above the machine).
Here are some general rules for testing and adjusting for paper skew or a shift in side-to-side registration.
1. Skew and side-to-side correction can be done only where the unit is docked to the upstream unit with
the bar joint connector (see above).
2. After installation of each peripheral device, do some test prints and check for the presence of skew,
and check that side-to-side registration is correct.
3. If you detect a problem with skew or side-to-side registration, do the adjustment on the bar joint bracket
attached to the peripheral unit upstream of the unit where the problem occurred.
4. Side-to-side registration is corrected by shifting the upstream joint bracket left or right.
Common Adjustments
2
237