Ricoh V-C3 D081 Field Service Manual page 972

4. Appendix: Service Program Mode Tables
These SPs set the switch the following free run modes for Finisher 2 (B830).
Touch [ON] to switch on, [OFF] to switch off.
1 Free Run 1
2 Free Run 1
3 Free Run 3
4 Free Run 4
6115 Input Check:Fin1
4
Use these SP codes to perform the input checks for either the 2000-Sheet Finisher D373 or
3000-Sheet Finisher D374.
The following abbreviations are used below:
• Sn: Sensor
• HP: Home Position
• Stp: Staple
• BStapler: Booklet Stapler (D373 only)
1 Entrance Sn
2 Proof Exit Sn
3 Proof Full Sn
4 Up Tray Exit Sn
5 Staple Exit Sn
6 Shift Roll HP Sn
7 Exit Sn
8 Exit Guide HP Sn
9 Low Tray Hgt Sn
10 Up Tray Hgt Sn
11 Up Tray Full Sn
12 Stack Roll HP Sn
13 Jogger HP Sn
394
System Free Run
Free Run (Endurance Testing)
Free Run
Shift, Free Run
2000/3000-Sheet Finishers D373/D374