Ricoh V-C3 D081 Field Service Manual page 564

6. Troubleshooting
[A] Scanner gamma curve – Machine 1
[B] Scanner gamma curve – Machine 2
6
[C] HDD – Machine 1
[D] HDD – Machine 2
[E] Printer gamma curve – Machine 1
[F] Printer gamma curve – Machine 2
To adjust the main machine:
1. Place the test charge Connection Kit Color Test Chart (P/N VSST9501) on the exposure glass, with
the arrow mark on the chart aligned with the left rear corner.
2. Do SP4954 001 (Read New Chart) and touch [Execute].
After about 10 seconds, the "Completed" message appears. If "Completed" appears immediately
after touching [Execute], the adjustment may have failed. Do the procedure again.
3. After doing SP4954 001, do the ACC procedure described in the "Installation" section for the main
machine.
To adjust the sub machine:
1. Do Steps 1 to 3 for the sub machine.
Compare the results
1. Set the two machines for full color, and do some sample color copies.
2. Compare the results from the two copiers. If the results are not good, do the procedure again from
step 1.
562