Ricoh V-C3 D081 Field Service Manual page 176

2. Installation
3. Align the right side of the finisher with the docking brackets [B] and [C] on the left side of the main
machine, and then slowly push the finisher onto the brackets.
4. Connect the finisher I/F cable [D] to the main machine.
5. Push in the locking lever and check that it slides into the slots of the docking brackets.
6. Check that the top edge of the finisher is parallel with the left edge of the main machine.
2
7. Refasten the locking lever [A] ( x1) and close the right front door.
Install the Shoes and Level the Finisher
1. Set the leveling shoes (x4) under the feet of the finisher.
2. Open the right front door and left front door.
3. Place a level on the frame
4. Use a wrench to turn the nut at each foot until the machine is level.
Attach Ring Supply Level Indicator
1. Open the front door.
2. Pull out the ring binder.
3. Lift the ring supply cartridge out of the top of the binder unit.
174