Ricoh V-C3 D081 Field Service Manual page 350

4. Replacement and Adjustments
4
5. At the center [A], disconnect springs from the post.
6. Disconnect the rear spring [B] from the rear bar support, then remove the support [C] from its post.
7. Disconnect the front spring [D] from the front bar supports, then remove the support [E] from its post.
8. Remove the drum lubricant bar [F] and replace it with a new one.
• The drum lubricant bars of the K PCU and YMC PCUs are identical. The same type of drum lubricant
bar can be installed in either type of PCU.
• The springs of the drum lubricant bar units are not interchangeable. The springs of the CMY drum
lubricant bar unit are brown and stronger than the springs of the K drum lubricant bar unit (the K drum
lubricant bar springs are black).
Re-installation: Drum Lubricant Bar, Drum Lubricant Blade
1. Enter the SP mode.
2. If you have replaced the drum lubricant bar, drum lubricant blade, or both bar and blade, do
SP2111-1 to do the MUSIC adjustment.
Drum Lubricant Brush Roller
1. Remove (see the previous section):
• Drum charge unit
• Drum lubricant bar
• Drum lubricant blade
348