Ricoh V-C3 D081 Field Service Manual page 733

HDD startup error at power on
HDD is connected but a driver error is detected, or the driver did not respond with
the status of the HDD within 30 s.
SC860 B
• HDD is not initialized
• Level data is corrupted
• HDD is defective (attempt to initialize the HDD with SP5832-001)
HDD re-try failure
At power on with the HDD detected, power supply to the HDD is interrupted, after the
HDD is awakened from the sleep mode, the HDD is not ready within 30 s.
SC861 D
• Harness between HDD and board disconnected, defective
• HDD power connector disconnected
• HDD defective
• Controller board defective
HDD data read failure
The data written to the HDD cannot be read normally, due to bad sectors generated
during operation.
SC863 D
• HDD defective
Note: If the bad sectors are generated at the image partition, the bad sector
information is written to NVRAM, and the next time the HDD is accessed, these bad
sectors will not be accessed for read/write operation.
HDD data CRC error
SC864 D
During HDD operation, the HDD cannot respond to an CRC error query. Data transfer
did not execute normally while data was being written to the HDD.
• HDD defective
HDD access error
SC865 D
HDD responded to an error during operation for a condition other than those for
SC863, 864.
• HDD defective.
Service Call Tables
GW
3
GW
GW
GW
GW
155