Ricoh V-C3 D081 Field Service Manual page 790

4. Appendix: Service Program Mode Tables
Displays the most recent ID sensor Vsg and Voffset readings.
Notes:
• Vsg_reg is the reading of the direct sensors in the black and color ID sensors that detect the
reflectivity of the bare surface of ITB. If Vsg_reg is less than 3.8V, the ID sensor may be dirty,
damaged, or disconnected
• If Voffset_reg is less than 0.15, the ID sensor should be replaced. (The ID sensors are
replaced as a unit.)
1 Vsg_reg
3 Voffset_reg
4
230
Temp/Humid Disp
2
This SP displays the current temperature and humidity. These readings are output by the
temperature humidity display located on the bottom of the machine below the used toner bottle.
1 Temp Disp
2 Rel Humidity Disp
3 Abs Humidity Disp
4 Current Env Disp
230
Force Temp Corr DFU
3
Force Ambient Temperature Correction. The temperature/humidity sensor reading is used to
adjust settings during process control when this SP is set to zero (the default). The value of the
absolute humidity reading displayed by SP2302 003, as well as the other readings of the
conditions around the machine displayed with SP2302, are used in the process control
calculations. If you touch any key (1 to 6) below, the value you select is used and the readings
of the temperature/humidity sensor are ignored.
Note: After you press any key (1 to 6), the setting you select remains in effect only while the
machine is in the SP mode. Once you leave the SP mode, this SP is reset to zero automatically.
212
Room temperature (°C).
[0 to 100/ 0/1 deg.]
Relative humidity (saturation point at current temperature).
[0 to 100/0 /1 %rh.]
Absolute humidity.
3
[0 to 63/ 0/ 0.01 g/m
Displays the current environment control mode. The control
modes are divided into 5 levels: LL, ML, MM, MH, HH.
]