Ricoh V-C3 D081 Field Service Manual page 716

3. Appendix: Service Call Conditions
SC783-13 B
3
SC783-14 B
SC784 B
138
FM2 Direct-Send JG Motor
The direct-send JG HP sensor did not detect the direct-send JG in (or out of) its
home position within the prescribed time. The 1st occurrence causes a jam, and
the 2nd occurrence causes this SC code.
• FM2 direct-send JG HP sensor dirty
• Sensor harness or connector loose, broken, defective
• FM2 direct-send JG motor harness or connector loose, broken, defective
• Sensor defective
• Motor or motor drive board defective
FM6 Pawl Motor
The FM6 pawl HP sensor did not detect the FM6 pawl in (or out of) its home
position. The 1st occurrence causes a jam, and the 2nd occurrence causes this
SC code.
• FM6 pawl HP sensor dirty
• Sensor harness or connector loose, broken, defective
• FM6 pawl motor harness or connector loose, broken, defective
• Sensor defective
• Motor or motor drive board defective
Z-Fold Timing Sensor Adjustment Error 1 Japan Only
The output voltage light emitted from the sensor changed, but the return input was not
sufficient to attain V0.
• Sensor, mirror dirty from paper dust, other particles
• Harness loose, broken, defective
• Mirror out of position
Multi Folder (D454)
Multi Folder (D454)