Ricoh V-C3 D081 Field Service Manual page 73

8. Check the tab on the side of the neck [1] to make sure that the bottle is locked. The neck of the bottle
should be perfectly flat on top of the PCU.
• There should be no gap between the developer bottle and the PCU.
• If the bottle is not locked in place, developer will spill from the bottle.
9. Repeat Steps 3 to 8 to install and lock the other bottles (M, C, K).
10. Remove the heat seal from each bottle.
• Hold the bottle [1] with one hand, slowly pull the heat seal [2] out of the developer bottle and
remove it.
• Do this for each bottle.
Main Machine D081/D082
2
71