Ricoh V-C3 D081 Field Service Manual page 842

4. Appendix: Service Program Mode Tables
Display Target Potential (VdDisplay)
Vd (read by the potential sensor) is the potential of dark areas of a drum before full laser
exposure. This SP displays the value of Vd used by processing control to determine the target
potential (Vd). The machine performs a calculation using development gamma, Vk and the
maximum coverage, and then uses the result to lookup and retrieve the correct voltage from
the Potential Table. This retrieved value is used to raise the charge of the charge roller that
charges the drums.
1 K
2 M
3 C
4
4 Y
3574 Target Poten:Vl
Display Target Potential (VlDisplay)
Vl (read by the potential sensor) is the potential of the exposed areas after full laser exposure.
This SP displays the value of Vl used by processing control to determine the target potential
(Vl). The machine performs a calculation using development gamma, Vk and the maximum
coverage, and then uses the result to lookup and retrieve the correct voltage from the Potential
Table. This retrieved value is used to raise the input current of the laser diode.
1 K
2 M
3 C
4 Y
3575 Dev DC Control
Display Value for Control of Development DC
Displays the development bias that was referenced during processing control and used in
the previous jobs (Used if process control is set for Auto with SP3501 001.)
264
[-999 to 0/1 V]
[-999 to 0/1 V]