Ricoh V-C3 D081 Field Service Manual page 182

2. Installation
2
2. Remove the spacers from the right side of the ring binder at the base ( x2).
3. On the docking bracket attached to the upstream unit, loosen the screws.
4. Insert a spacer and tighten the screws.
If the trailing edge is skewing toward the front of the machine, insert a spacer [A] under the rear end
of the bracket and tighten the screws.
-or-
If the trailing edge is skewing toward the rear of the machine, insert a spacer [B] under the front end
of the bracket and tighten the screws.
5. To another run to check the adjustment. If skew is still present, insert another spacer.
180