Ricoh V-C3 D081 Field Service Manual page 242

2. Installation
3. Execute a straight-through run.
4. Check the scale where each sheet exits.
• The rear scale is for DLT-size paper.
• The front scale [2] is for A3-size paper.
• Be sure to read the correct scale for the paper size in use.
2
[A]
[B]
[C]
Correcting Skew
1. Disconnect the peripheral unit from the upstream unit.
2. Locate and remove the spacers from the peripheral unit where the problem occurred.
Locating and Removing Spacers
The photos below show where you can find the spacers for each unit.
240
Centered. No adjustment necessary.
Trailing edge skew to the front, total skew more than ±2 mm. Adjustment required.
Trailing edge skew to the rear, total skew more than ±2 mm. Adjustment required.