Ricoh V-C3 D081 Field Service Manual page 228

2. Installation
2. Remove the SD card slot cover [A] from the main machine ( x 1).
3. Insert an SD card [B] that contains the latest firmware for this finisher, downloaded from the web site.
Insert this SD card into the service slot (lower slot).
• If you do not have the latest firmware, use the SD card that is provided with the finisher adapter
2
kit. However, the firmware on this card may be old.
4. Open the front door of the main machine.
5. Switch on the machine. A message prompts you to wait for the update procedure to begin, then the
initial screen appears.
6. Write down the NEW version numbers. (You will need these later to confirm the success of the firmware
update.)
7. Touch "Finisher" then touch "Update".
8. Wait for the update procedure to begin.
• The update may not start for 2 or 3 minutes.
• When the first asterisk (*) appears in the progress bar this means the update has started.
• The update procedure is very slow. Wait for all the hyphens (-) to be replaced by asterisks (*)
in the progress bar.
• Never switch off the machine while the update is in progress.
9. After asterisks have replaced all the hyphens in the progress bar, switch off the machine.
10. Remove the SD card from the SD card slot and reattach the SD card slot cover.
11. Close the front door.
12. Switch on the machine.
13. Enter the SP mode and do SP5990-5 to print the self-diagnostic report.
14. Confirm that the finisher firmware updated successfully.
• For "Finisher 1", you should see the numbers that you saw for the NEW column in the initial
screen at Step 6.
• If you see these numbers, the update has executed successfully.
• If the update fails, turn the machine off and try the procedure again.
15. Switch the machine off and remove the SD card.
16. Switch the machine on.
This completes the firmware update procedure.
226