Ricoh V-C3 D081 Field Service Manual page 273

Description
1. Gigabit Ethernet PCB
2. Protector Plate
3. Screws
Installation
1. Remove:
• Rear upper cover.
• Controller box cover
• Cover [A] of Slot C ( x1)
2. Insert the edge connector of the gigabit Ethernet PCB [B] into its slot on the controller board.
3. On the other side of the faceplate, fasten the PCB ( x2).
4. Attach the cable.
5. With the prongs of the protector plate [D] on both sides of the attached cable, fasten the protector
plate to the controller box face plate ( x1).
Qt'y
1
1
3
MFP Controller Options
2
271