Ricoh V-C3 D081 Field Service Manual page 269

2. Remove the seals from both corners of the packet. The silver "VOID" notations [B] become visible only
after you have removed the seals. This is normal.
Installation Procedure
• Before doing the procedure, turn off the main power switch and unplug the machine from its power
source.
1. Make sure that the machine is switched off and disconnected from its power source.
2. Disconnect the network cable.
3. Turn the main power switch on.
4. Turn the operation switch and main power switch off.
• Make sure that the number and "Type" are correct (Type H, D377). If you install the incorrect
version of this application, the NVRAM must be replaced.
5. Remove the SD card slot cover [A] ( x1).
6. Remove the security tape from the SD card wrapping.
• If you see "VOID" on the security tape this means that the tape has been removed.
• If the "VOID" notations are visible, do not use the SD card for this installation. Contact your sales
division
MFP Controller Options
2
267