Ricoh V-C3 D081 Field Service Manual page 979

Use this SP to adjust the timing of the top fence motor that positions the top fence.
Note: After all the pages of a stack have been fed onto the stapling tray, the top fence jogs
the stack vertically to align the leading edge of the stack for stapling.
1 A4 LEF
2 B5 LEF
3 LT LEF
4 Other
6155 Staple Stack Jogging
Touch [1:+1 Time] to have the jogger fences press against the sides of the stack on the staple
tray one more time to align the stack for corner stapling.
[0:Default] [1:+1 Time]
6156 Input Check:Fin2
Use these SP codes to perform the input checks for either the 3000-Sheet Finisher B830. The
following abbreviations are used below:
• Sn: Sensor
• Hgt: Height
• HP: Home Position
• Stp: Staple
• BStapler: Booklet Stapler (D373 only)
1 Entrance Sn
2 Proof Exit Sn
3 Shift Exit Sn 1
4 Stp Exit Sn
5 Tray Bot Plt Sn
6 Tray Near Bot Sn
7 Release HP Sn
8 Jogger HP Sn
[-5 to 10/0/0.1 mm]
[-5 to 2/0/0.1 mm]
[-5 to 10/0/0.1 mm]
3000-Sheet Finisher B830
Group 6000
4
401