Ricoh V-C3 D081 Field Service Manual page 254

2. Installation
14. Turn the main machine on.
15. Go into the User Tools mode and confirm that all the applications on the SD card in Slot 2 (upper slot)
are enabled.
User Tools> System Settings> Administrator Tools> Firmware Version> Next...
16. Turn the main machine off.
2
17. Remove the cover from the front door, and store the SD card that was copied. (See "Storing SD
Application Cards on Site"). The SD card must be stored with the machine for these reasons:
• Once an SD card has been copied, it can no longer be used. But it must be stored in the front
door to serve as proof of purchase by the customer.
• Also, at a later time the stored SD cards can be restored to full use with SP5873-2 (described
in the next section).
• Before you put the card in the front cover, label it so that it can be easily identified.
18. If the client is using App2 Me or any other applications on the VM card, do the procedure to re-start
these applications. (
Undo Exec
1. Remove the SD card slot cover ( x 2).
• Before removing the VM card from Slot 1 (lower slot) you must shut down the App2 Me
application (and any other VM card applications) if it is running. See p.305 "Before Removing
and Re-installing the VM Card".
2. Turn the main switch off.
3. Put the SD card with the applications in Slot 2 (upper slot).
4. Put the original destination SD card (the one stored in the front door) in Slot 1 (lower slot).
• The SD card in the lower slot must be the original (empty) SD card of the application that you
want to move from the upper slot to the lower slot.
• You cannot use any blank SD card in the lower slot. The application can be moved only to an
original SD card.
5. Turn the main switch on.
6. Go into the SP mode and do SP5873-2 (Undo Exec)
7. Follow the messages on the operation panel to complete the procedure.
8. Turn the main switch off.
9. Remove the SD cards from the slots.
10. Insert the VM card in Slot 1 (lower slot).
252
p.305 "Before Removing and Re-installing the VM Card")