Ricoh V-C3 D081 Field Service Manual page 300

4. Replacement and Adjustments
4
1. Confirm that the transfer belt release lever [A] is up and locked before you reattach the hopper.
2. Make sure the hopper rails are fully extended, then set the toner hopper [B] on the rails,
3. Make sure the steel tabs of the hopper are inserted into the holes in the left rail [C] and right rail [D].
4. Push up the release [E] and support leg [F].
• Make sure that the support leg is up and locked before you push the toner hopper into the
machine.
5. Place your hands at the bottom of the toner hopper at (1) and (2) then push the hopper against the
face plate.
• To avoid damaging the hopper, never press on the top of the toner hopper.
6. Check the right side and confirm that the hopper unit is flat against the faceplate.
If the toner hopper [B] is not flat against the face plate on the right side, pull it out slightly and make
sure that the transfer belt release lever is rotated up completely and locked.
7. Fasten the toner hopper to the face plate ( x3).
298