Ricoh V-C3 D081 Field Service Manual page 208

2. Installation
2
9. Put the side-to-side detection unit [A] in the machine. Make sure that the two pins are engaged correctly
at the front.
10. Make sure that the side-to-side detection unit moves smoothly on its rails. If it does not, make sure that
the rails are aligned with their grooves.
11. Attach the side-to-side detection unit and connect it at the rear ( x 2,
12. Pull the short connector out of the connector [B] then connect the cable (
• This is the 3-pin connector.
13. At the front, use a pair of wire cutters to remove the part [A] of the cover.
14. Install the punch-waste transport unit [B] in the finisher.
206
x 1, x 1).
x 1).